Adding texture to the surface of a plastic injection molded part, whether it’s to a portion of the surface or…
Read More
Surface finish on plastic injection molded parts serves both functional and aesthetic purposes. The texture or pattern of a part…
Read More
Dan Sullivan joined Molded Dimensions Group as the General Manager of PCO Urethane in December 2022, with a goal to…
Read More
Draft is a taper, or angled face, that is added to the design of injection molded parts to assist with…
Read More
Rubber and urethane temperature capabilities / Temperature capabilities of basic elastomers
Read More
When new to the injection molding industry, many people inquire as to why injection molds have a high cost. Often,…
Read More
All designers need to pick a material to make their parts, but matching an application to a specific plastic can…
Read More
Wall thickness is crucial in the design and development of injection molded parts. Each molding resin has different optimal ranges…
Read More
Urethane elastomers have a higher load-bearing capacity than do conventional elastomers of comparable hardnesses. This permits the design of smaller…
Read More
